Reset and Calibration for 2017 V2450GPS and 2018 Scout and Journey Models
Note: Not all of these calibrations are necessary unless you run the Factory Reset. Steps 2-4 can be done without completing the factory reset once you are connected and on the WEB interface.
Text File of these instructions available below.
(Full Reset & Calibration)
STEP 1-Factory Reset
Power on your Drone and pair to controller
From your computer, connect to the drones WiFi connection (Skyviper17_xxxx)
Once connected, Open a web browser and go to http://fly.sky-viper.com/calibration.html
Select System Control. Scroll down to factory reset, and select.
(Power off the drone and controller, and then power on and pair drone and controller).
STEP 2-Six Axis Calibration
Return to the Web page again (following instructions above IN STEP 1).
Select "Start Six-Axis Calibration, follow instructions.
Once complete, Power off the drone and controller, and then power on and pair drone and controller
STEP 3-Motor Calibration
Return to the Web page again (following instructions above in step 1).
Select "MotorCal" from the tabs at top
Select "Start MotorCal Calibration" (Allow this to run, you will see the propellers on the drone spin briefly, one at a time).
When all 4 motors have finished spinning, go to next step
STEP 4-Magnetometer Calibration
Select "Magnetometer" from the tabs at top
Select " Start Magnetometer Calibration". Once you select start, hold the drone in your hands and continue to rotate it in various directions. You will see a bar filling on the screen.
Continue rotating until the bar fills and says complete.